Interp Management

The FcrvEdit->Interp Management command in the Motion module sets the interpolation mode for each segment of the function curve. You can also perform this action by selecting the INTERP option from the Fcurve window title bar.

The mouse buttons are configured as follows:

• Left-click a key point to set the segment (to the right of the key point) to spline interpolation.
• Middle-click a key point to set the segment to linear interpolation.
• Right-click a key point to set the segment to constant.

Note:

You can also activate interpolation management by using the i Supra key.

Last updated 02-apr-1998