Detach/Delete Hole

The Draw->Attach Hole command.

After the Attach Hole operation, the original curve remains in the same spot as the now-attached hole.

This superimposition may cause confusion when you trying to delete or detach the hole in the face. You may unknowingly select the original curve instead of the hole. To avoid this problem, move or delete the original curve (use the Schematic window to select it) before performing operations on the face.

Procedure

1. Select the face which has a hole you want to delete or detach.
2. Choose the Draw->Detach/Delete Hole command.
3. Middle-click the hole to delete it entirely, or left-click the hole to detach it from the face (but still retain the hole).
4. Right-click to end the mode.

Last updated 08-apr-1998